Inspection Conveyor with Reject System
Reject Conveyor Description
To manufacture a split belt conveyor handling cardboard containers of liquid as part of a vision / reject system
Product: | Cardboard containers of liquid |
Sizes: | 57 x 57mm & 74 x 74mm footprints |
Belt Speed: | 15 m/min Throughput: Up to 55/min |
Reject Inspection Conveyor Video
Twin Side Grip Belt Conveyor and Reject System
1 Set of Twin Side Grip Belt Conveyors each being nominally 80mm wide x 1000mm long x 800mm high.
The two belts have a high grip surface and both conveyors are linked as a pair and mounted on a bevel gear shaft/bearing housing arrangement with a common shaft mounted drive.
The conveyors can be adjusted in and out from 50mm to 100mm via a simple slotted bracket arrangement and locked into position.
The conveyors were 1000mm long and overhang the support frame ends equally to assist in the infeed / discharge conveyors interface.
There is an open area of 300mm at the centre to allow the camera to look through from below as the product passes above and determine if it is to be rejected.
The equipment is intended to transfer the product by gripping via the sides.
The product thn transfers onto a Small Belt Conveyor being 150mm wide x 1000mm long x 800mm high supplied with adjustable side guides vee track and end drive. Centrally positioned, halfway along is a pneumatically operated reject pusher operated by a double acting 24Vdc solenoid valve.
Rejected products are collected in a side mounted bin designed to retrieve the products via a tray opening below.
The side grip & small belt conveyors are mounted on common box section framework supplied with adjustable feet +50mm.
General fabrication was grade 304 stainless steel and food quality materials where possible, shaft mounted geared motor drive units were included.